AKI CHARGER DENGAN LAMPU INDIKATOR LED
Rangkaian dibawah ini sangat saya anjurkan bagi anda yg ingin merakit charger aki maksimum arus 1 A. Karena dilengkapi indikator pengisian layaknya Jarum Ampermeter. Lampu indikator akan meredup dan mati yg menandakan baterai terisi penuh.
If the battery charger is not properly connected to the battery terminals, charging will not takes place. If the terminals, connecting clips etc are dirty or corroded, current will not pass into the battery. So even after prolonged charging, the battery will not attains full charge. The only way to confirm the flow of current is to connect an ampere meter in series with the positive so that when current passes, the needle deflects based on the amount of current passing. Here an LED indication is used to confirm the current flow into the battery.
The battery charger circuit use a 0 – 18 volt 500 mA step-down transformer as low voltage AC source and diodes D1 through D4 as a full wave rectifier. The rectified DC is made ripple free by the smoothing capacitor C1. A positive voltage regulator IC 7815 is used to provide 15 volt regulated DC for charging. Regulated 15 volt DC passes through the LED and R1 at power on and LED glows in full brightness. LED used in the circuit is the new version low current 1 volt LED. When T1 gets sufficient base bias, it conducts and bypasses the voltage to the battery and the LED’s brightness reduces. LED turns on only when the clips are properly connected to the terminals, and its brightness reduces when the battery takes current. During the charging process, battery gets more than 13 volts which is sufficient for charging the Lead Acid battery.
If the battery charger is not properly connected to the battery terminals, charging will not takes place. If the terminals, connecting clips etc are dirty or corroded, current will not pass into the battery. So even after prolonged charging, the battery will not attains full charge. The only way to confirm the flow of current is to connect an ampere meter in series with the positive so that when current passes, the needle deflects based on the amount of current passing. Here an LED indication is used to confirm the current flow into the battery.
The battery charger circuit use a 0 – 18 volt 500 mA step-down transformer as low voltage AC source and diodes D1 through D4 as a full wave rectifier. The rectified DC is made ripple free by the smoothing capacitor C1. A positive voltage regulator IC 7815 is used to provide 15 volt regulated DC for charging. Regulated 15 volt DC passes through the LED and R1 at power on and LED glows in full brightness. LED used in the circuit is the new version low current 1 volt LED. When T1 gets sufficient base bias, it conducts and bypasses the voltage to the battery and the LED’s brightness reduces. LED turns on only when the clips are properly connected to the terminals, and its brightness reduces when the battery takes current. During the charging process, battery gets more than 13 volts which is sufficient for charging the Lead Acid battery.
0 Response to "AKI CHARGER DENGAN LAMPU INDIKATOR LED"
Post a Comment